Instrukcja obsługi D-Link SharePort Go II DIR-508L

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla D-Link SharePort Go II DIR-508L (4 stron) w kategorii Punkt dostępu. Ta instrukcja była pomocna dla 25 osób i została oceniona przez 2 użytkowników na średnio 4.3 gwiazdek

DIR-508L

SharePort™ Go II

Wireless N300 Portable Router

and Charger

If any of the above items are missing, please contact your reseller.

Package Contents

• DIR-508L Portable Router

• 4000 mAh Li-ion battery

• Power Adapter

• Quick Install Guide

Thank you for purchasing the DIR-508L Portable Router and

Charger. Follow the easy steps in this guide to properly set

up your router.

Quick Install Guide

LEDColor StatusDescription

Power/Status

LED

Green

Solid The device is connected to the Internet and properly

working.

BlinkingThe device is processing WPS.

Orange

SolidDevice is powering up.

Blinking

Cannot connect to the Internet or receive an IP address

from the uplink side. This may also indicate that the device

is in recovery mode.

RedSolidThe device is defective.

ODevice is turned o or in charging mode.

Battery LED

GreenSolidBattery is at 80% or higher capacity.

OrangeSolidBattery is between 15% and 80% capacity.

Red SolidBattery is lower than 15% capacity.

BlinkingBattery is malfunctioning.

O Charging completed. (adapter plugged)

Out of battery.

Reset Button

SD Card Slot

Power PortInternet Port

USB Port

WPS Button

Mode Switch

Up = On

Middle = O

Down = Charger

Power/Status

Battery

Product OverviewCharge and Connect

1 4

5

6

Make sure the DIR-508L is charged* or plugged in before using.

2Slide the mode switch up to On. Allow

one minute for the device to boot up.

ON

OFF

Charger

3From your device’s wireless utility, connect to the DIR-508L.

The default network name (SSID) is DIR508L with no password.

* Actual usable capacity may vary depending on charging conditions.

Open a web browser (e.g., Internet Explorer, Firefox,

Chrome, or Safari) and go to http://dlinkrouter.local./

(or http://192.168.0.1).

At the login screen, click or press

the Log inbutton (no password).

Click or press the ! icon to select a wireless network (HotSpot

Mode). You may instead connect an Ethernet cable from an

Internet source such as a broadband modem to the Internet

port (see note below).

Note:If you are connecting directly to a broadband modem and are using either PPPoE or a

static IP connection, click or press SettingsInternet Proles > and create a new prole with your

Internet connection type. A dynamic connection (e.g., Cable) will connect automatically without

conguration.

Please refer to the user manual available at http://www.dlink.com/DIR-508Lfor more

information.

Specyfikacje produktu