Instrukcja obsługi Dimplex RX9913
                    Dimplex
                    
                    Niesklasyfikowane
                    
                    RX9913
                
                                
    Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Dimplex RX9913 (1 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 19 osób i została oceniona przez 10 użytkowników na średnio 4.6 gwiazdek
                        Strona 1/1
                    
                    
                    
Installation and 
Operating Instructions 
Receiver Cassette - Model No. RX9913 
General Description 
Installation 
Dedicating A Zone: 
Setting Temperatures: 
Manual Override: 
Locking the receiver: 
General Cleaning 
After Sales Service 
The RX9913 can be used in RPX, EPX, MFP, GFP and LPP heaters and with a master heater fitted with 
the Mains Signalling Transmitter (Part No. RX9912). 
They operate by receiving a high frequency signal from the master heater transmitter (RX9912). During set 
up receivers are  dedicated  to  only  one transmitter so that  they cannot  be activated  by signals  from  any 
other transmitter unit. 
1.  Using a narrow bladed screwdriver, carefully release the cover from the slot adjacent to the controls 
  on the heater 
2.  Insert the receiver fully so that it clicks into position 
3.  Turn the control knob on the heater to the PROG position (RPX models only) 
INSTALLER PLEASE NOTE: 
Please  mark  clearly  on  the  receiver  label  the  number  of  the  zone  allocated,  if  used  in  a  multi  zone 
application. The RX9913 is rated at 230V.  
Firstly read the   user instructions for operating with the receiver, following Mains  Signalling  Transmitter
the steps listed under single or multi-zone programming. 
1.  When the master  programmer  starts to  flash  the EMET message and required 
  zone number, press the small button (A) for 10  seconds until the indicator neon 
  (B) flashes. 
2.  Release and press again, neon indicator will be  continuously. ON 
For heaters fitted with receivers, set the temperature controls in the normal way. 
(Refer to heater instructions). 
Turn  the  control  button  on  the  slave  heater  to  the  required  position  (comfort,  setback,  frost  or  off).  To 
cancel override and return to programmed operation, turn back to the PROG position. (RPX models only) 
An extra screw is supplied to lock the receiver in place. Lock by piercing the prominent spur on the side of 
the heater casing until the screw enters a matching hole in the receiver. 
WARNING 
BEFORE UNDERTAKING CLEANING WORK ON THE  CONTROLLER  OR  APPLIANCE IMMEDIATELY 
DISCONNECT THE ELECTRICITY SUPPLY BY SWITCHING OFF AT THE ADJACENT DOUBLE POLE 
SWITCH. 
The outside  of  the  appliance  should  be  wiped  over  with  a  soft  damp cloth  and  then dried.  Do  not  use 
detergents or abrasives. 
Your product is guaranteed for one year from the date of purchase. Within this period we undertake to 
repair or exchange this product free of charge provided it has been installed and operated in accordance 
with these instructions. 
Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this 
guarantee. Should you require after sales information or assistance with this product please go to 
www.dimplex.co.uk where you will find our self help guide by clicking on “After Sales” or call our helpdesk 
on 0845 600 5111 (UK) or 01 842 4833 (R.O.I.). 
Spare parts are also available on the website www.dimplex.co.uk 
Please do not return a faulty product to us in the first instance. Please retain your receipt as proof of 
purchase. 
Display 
Glen Dimplex UK Ltd 
Millbrook House 
Grange Drive 
Hedge End 
Southampton 
SO30 2DF   
Customer Help Line   
Tel: 0845 600 5111  
E-mail: customer.services@dimplex.co.uk 
Web-site: www.dimplex.co.uk 
Republic of Ireland Tel: 01 842 4833  
A
B
Neon Indicator
Activate Button
Label to indicate 
zone number
Issue 2 08/13 
Specyfikacje produktu
| Marka: | Dimplex | 
| Kategoria: | Niesklasyfikowane | 
| Model: | RX9913 | 
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Dimplex RX9913, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Niesklasyfikowane Dimplex
                        
                         13 Stycznia 2025
                        
                    
                                                            
                        
                         30 Grudnia 2025
                        
                    
                                                            
                        
                         2 Października 2024
                        
                    
                                                            
                        
                         2 Października 2024
                        
                    
                                                            
                        
                         30 Września 2024
                        
                    
                                                            
                        
                         28 Września 2024
                        
                    
                                                            
                        
                         27 Września 2024
                        
                    
                                                            
                        
                         22 Września 2024
                        
                    
                                                            
                        
                         20 Września 2024
                        
                    
                                                            
                        
                         20 Września 2024
                        
                    
                                                            Instrukcje Niesklasyfikowane
- Redsbaby
- ZKTeco
- Roesle
- United Office
- Lumu
- Wilson
- BigBlue
- Boss
- Steren
- Cooler Master
- Williams Sound
- Sparco
- Lasita Maja
- Integral
- ESX
Najnowsze instrukcje dla Niesklasyfikowane
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025