Instrukcja obsługi Ditek DTK-GLI

Ditek nieskategoryzowany DTK-GLI

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Ditek DTK-GLI (1 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 15 osób i została oceniona przez 8 użytkowników na średnio 4.7 gwiazdek

Pobierz PDF

Strona 1/1

Doc # INT-100151-001

Part No. 191576 Rev. 1

INSTALL INSTRUCTIONS

DTK-GLI

DITEK Technical Support Available 24/7

1-888-472-6100

www.ditekcorp.com

DITEK Corporation

ONE DITEK CENTER

1720 Starkey Road

Largo, FL 33771

INSTALLATION

This is a high performance device, designed to provide protection

from video signal distortion caused by video ground loops.

Please read and follow the installation instructions carefully.

NOTICE: This SPD should be installed by a qualiﬁed electrician in accordance with the National

and Local Electrical Codes and the following instructions.

APPLICATION

Ground Loop Isolator for use on analog CCTV systems experiencing video distortion.

INSTRUCTIONS:

Caution: This unit must be connected in series with the equipment to be protected.

Improper installation voids the warranty.

1. Connect the incoming coaxial feed normally intended for the Input side of the “Head End” equipment.

Such as the multiplexer, switcher, DVR, and monitor. To the “Input” side of the DTK-GLI.

2. Connect a 3’ BNC patch cable from the DTK-GLI “Output” to the Input side of the “Head End” equipment.

3. For mounting, use double sided tape (supplied), or two (2) #8 screws (not supplied).

Note: The DTK-GLI does not provide any surge protection and is vulnerable to the same path of surge as

your CCTV components. We recommend using the DTK-PVP27B (ﬁxed analog cameras) or the DTK-DP4P

(PTZ analog cameras) installed using a 3’ BNC patch cable from the DTK-PVP27B or DTK-DP4P Output

to the DTK-GLI Input.

Drawn By: R. Mitchell 7-3-13

Approved By: J. Ramirez 7-3-13

DTK-GLI

3’ BNC Patch Cord

Camera

Camera Output Input Output

DTK-GLI

3’ BNC Patch Cords

Camera

Camera Output Input Output

GND

VIDEO

DTK-DP4P

OUT IN

5V DATA

12/24 V PWR

Input Output

DTK-DP4P

Specyfikacje produktu

Marka:	Ditek
Kategoria:	nieskategoryzowany
Model:	DTK-GLI
Kolor produktu:	Czarny
Wysokość produktu:	33.02 mm
Szerokość produktu:	76.2 mm
Waga produktu:	113 g
Ilość:	1
Zasięg częstotliwości:	- Hz
Impedancja wejściowa:	75 Ω
Impedencja wyjścia:	- Ω
Tłumienność:	1.1 dB