Instrukcja obsługi Doepfer A-176

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Doepfer A-176 (6 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 15 osób i została oceniona przez 3 użytkowników na średnio 4.9 gwiazdek

doepfer System A - 100Control Voltage SourceA-176

1

1. Introduction

Module A-176 (Control Voltage Source) provides

threevoltage sources, to use wherever an extra CV

is required.

The top two voltage sources (CV 1 and CV 2) have

controls for coarseand finecontrol of the voltage

output; the third source (CV 3) just has the one control.

The range of the voltages output can be preset, either

to 0 to +5 V or to -2.5 V to +2.5 Vdepending on your

likely requirements. There is a jumper on the circuit

board for each of the three voltage sources.

A typical use for the module would be to provide fine

as well as coarse tuning for an A-110 standard VCO,

(which, unlike the A-111, only has one tune control),

See chapter 5, user examples.

In general, this module will be useful whenever you

need a manually controllable CV on a module which

doesn’t itself have a built-in control.

CV 3

Contr. Volt. Source

CV 1

Fine

CV 3

CV 1

CV 2

Fine

CV 2

Specyfikacje produktu