Instrukcja obsługi Indesit I3B L634 X

Indesit Pomywaczka I3B L634 X

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Indesit I3B L634 X (8 stron) w kategorii Pomywaczka. Ta instrukcja była pomocna dla 26 osób i została oceniona przez 13.5 użytkowników na średnio 4.4 gwiazdek

Strona 1/8
ENQuick Guide
1
PROGRAMS TABLE
Program Programs description
Drying
phase
Auto Door
Available
options
*)
of wash
program
(h:min)
**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
1.
Eco 50° - Eco program is suitable to clean normally soiled tableware. that
for this use. it is the most ecient program in terms of its combined ener-
gy and water consumption. and that it is used to assess compliance with
the EU Ecodesign legislation.
3:10 9.5 0.85
2.
Intensive 65° - Program recommended for heavily soiled crockery. espe-
cially suitable for pans and saucepans (not to be used for delicate items).
2:50 17.0 1.60
3.
Mixed 55° - Mixed soil. For normally soiled dishes with dried food residues.
3:00 15.0 1.40
4.
Fast&Clean 28’ 45° - Program to be used for half load of lightly-soiled
dishes with no dried food residues. Does not have drying phase.
-
0:28 9.0 0.50
5.
Pre-Wash - Use to refresh crockery planned to be washed later. No deter-
gent to be used with this program.
- -
0:12 4.5 0.01
6.
Push&Go - 50° Everyday wash and dry cycle that ensures great cleaning
performance in a short time without the need to pre-treat dishes.
1:25 11.5 1.10
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020. Note for Test Laboratories: For information on
comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature and
pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor cali-
bration. The sensor calibration can increase program duration up to 20 min.
CONTROL PANEL
1. On-O/Reset button with indicator
light
2. Program selection button with
indicator light
3. Half Load button with indicator light
4. Rinse Aid rell indicator light
5. Salt rell indicator light
6. Program indicator lights
7. Delay indicator light
8. Delay button with indicator
light
9. Push&GO button with indi-
cator light
10. Start/Pause button with
indicator light / Drain out
FIRST TIME USE
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and on
the machine’s functional components.
It is mandatory that the salt reservoir never be empty.
It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher and must be
lled when the SALT REFILL indicator light in the control panel is lit.
1. Remove the lower rack and unscrew the reservoir cap
(anticlockwise).
2. Position the funnel and ll the salt reservoir (see gure)
right up to its edge (approximately 1 kg); it is not unu-
sual for a little water to leak out.
3. Only the rst time you do this: ll the salt reservoir
with water.
4. Remove the funnel and wipe any salt residue away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get into the
container during the wash program (this could damage the water softener be-
yond repair). Whenever you need to add salt, it is mandatory to complete the
procedure before the beginning of the washing cycle to avoid corrosion.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse
aid dispenser should be lled when the A RINSE
AID REFILL indicator light in the control pan-
el is lit. NEVER pour the rinse aid directly into the
appliance tub.
A
C
D
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device . Introduce the C
detergent into the dry dispenser only. Place the amount of detergent for D
pre-washing directly inside the tub.
Usage of detergent not designed for dishwashers may cause malfunc-
tion or damage to the appliance.
WATER SOFTENING SYSTEM
Water softener automatically reduces water hardness, consequently pre-
venting scale buildup on heater, contributing also to better cleaning e-
ciency. This system regenerates itself with salt, therefore it is required
to rell salt container when empty.
Frequency of regeneration depends on water hardness level setting - regen-
eration takes place once per 6 Eco cycles with water hardness level set to 3.
Regeneration process starts in nal rinse and nishes in drying phase, be-
fore cycle ends.
Single regeneration consumes: ~3.5L of water;
Takes up to 5 additional minutes for the cycle;
Consumes below 0.005kWh of energy.
1 2
43 5 6 7
8
9
10
THANK YOU FOR BUYING AN INDESIT PRODUCT.
In order to receive a more complete assistance, please register
your appliance on: www.indesit.com/register
Before using the appliance carefully read Safety Instructions
guide.
PLEASE SCAN THE QR CODE ON YOUR
APPLIANCE IN ORDER TO HAVE MORE
DETAILED INFORMATION


Specyfikacje produktu

Marka: Indesit
Kategoria: Pomywaczka
Model: I3B L634 X

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Indesit I3B L634 X, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Pomywaczka Indesit

Indesit

Indesit D63 Instrukcja

19 Stycznia 2025
Indesit

Indesit idl 600 Instrukcja

15 Stycznia 2025
Indesit

Indesit UNODUE Instrukcja

11 Października 2024
Indesit

Indesit D2F HD624 A Instrukcja

8 Października 2024
Indesit

Indesit I3B L634 X Instrukcja

7 Października 2024
Indesit

Indesit I3I D741O Instrukcja

7 Października 2024

Instrukcje Pomywaczka

Najnowsze instrukcje dla Pomywaczka