Instrukcja obsługi Lancom CS-8132F

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Lancom CS-8132F (1 stron) w kategorii przełącznik. Ta instrukcja była pomocna dla 18 osób i została oceniona przez 3 użytkowników na średnio 4.3 gwiazdek

Hardware Quick Reference







i

Before initial startup, please make sure to take notice of the information regarding

the intended use in the enclosed installation guide!

Operate the device only with a professionally installed power supply at a nearby

power socket that is freely accessible at all times.

All power plugs of the device must be freely accessible.

Please note that support for third-party accessories is not provided.







Mounting & connecting

LED description & technical details









































Use an Ethernet cable to use this out-of-band service port

for an IP interface independent of the switching plane for

management tasks or connection to a monitoring server.

In particular, this port can be used as a VPC-keepalive link

(split-brain detection).





Connect a USB stick to the USB interface to store general

configuration scripts or debug data. You can also use this

interface to upload a new firmware.





Connect the configuration interface to the USB interface of

the device you want to use for configuring / monitoring the

switch using the serial configuration cable supplied.





10G SFP+ in-band management interface

(for future use)





Insert suitable LANCOM transceiver modules into the QSFP28 interfaces 1 to 32.

Choose cables which are compatible with the transceiver modules and connect them as

described in the transceiver modules mounting instructions:

lancom-systems.com/transceiver-modules-mi.





Use the enclosed grounding bracket with screw to secure the switch against ground.





To remove a fan module in case of defect, loosen the knurled screw of the module and

remove the module from the plug-in unit. To install a new fan module, push it into the

corresponding slot. Fasten the module to the switch housing with the knurled screw.

Please note that a defective fan should be replaced within 48h.





Supply the device with power via the power supply sockets of the power supply

modules. Use the supplied power cords or a country-specific LANCOM Power Cord.

To remove the power supply module, disconnect the module from the power supply and

then pull the plug out of the module. While pressing the release lever to the left, you 

can pull the module out of the device by the handle



.

FAN

2

FAN

1

FAN

0



CS-8132F

SYS

FAN

PSO

PS1

ID

MGMT

RESET

SS

3132293027282526232421221920171815161314111291078563412











































Left LED







Right LED













































































LANCOM CS-8132F

CS-8132F

SYS

FAN

PSO

PS1

ID

MGMT

RESET

SS

15161314111291078563412





FAN

0

















Specyfikacje produktu