Instrukcja obsługi LiftMaster LA400UL


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla LiftMaster LA400UL (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 5.5 użytkowników na średnio 4.7 gwiazdek

Strona 1/2
Doc 6001309 (01-20289) Page 1 of 2 Rev A
Use the following procedure to remove and replace a LiftMaster Swing Gate Operator cover:
WARNING
Failure to follow the instructions in Step 1 may cause injury due to unexpected gate movement.
Always wait one minute after power-off to service the gate.
1. Turn off power to the gate operator at the circuit breaker and wait for one minute. The gate
will move after one minute if system has the Power Fail Option.
2. When you are certain that the gate will not move due to Power Fail Option operation:
A) Disconnect the Drag Link from the gate Anchor.
B) Loosen the locking nut and mounting bolt, then remove the Swing Arm Cap Assembly and
Drag Link Assembly from the drive shaft. Set this assembly aside.
3. Remove the four cover mounting bolts and remove the gate operator cover.
4. If new cover has optional door: Remove the two top mounting screws from the control box clear
plastic cover. NOTE: These screws must be removed or the control box clear plastic cover cannot
be removed through the gate operator cover door.
5. Install the new gate operator cover and secure with mounting hardware.
6. Reinstall the Drag Link, Swing Arm and Swing Arm Cap Assemblies.
7. Turn on power to the gate operator at the circuit breaker.
Swing Gate Cover Removal and Installation.
SWING GATE OPERATOR COVER
REMOVAL AND INSTALLATION
(WITH OR WITHOUT DOOR)


Specyfikacje produktu

Marka: LiftMaster
Kategoria: Niesklasyfikowane
Model: LA400UL

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z LiftMaster LA400UL, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niesklasyfikowane LiftMaster

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

SmallRig

SmallRig VB99 SE Instrukcja

29 Stycznia 2025
QSC

QSC TSC-8 Instrukcja

29 Stycznia 2025
XTRARM

XTRARM XTR-FS5130 Instrukcja

29 Stycznia 2025
Sunding

Sunding SD-581G Instrukcja

29 Stycznia 2025
XTRARM

XTRARM XTR-FS5070 Instrukcja

29 Stycznia 2025
XTRARM

XTRARM XTR-FS2010 Instrukcja

29 Stycznia 2025
OSEE

OSEE TX402 Instrukcja

29 Stycznia 2025