Instrukcja obsługi Netgear ProSafe AX745

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Netgear ProSafe AX745 (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 21 osób i została oceniona przez 8 użytkowników na średnio 4.1 gwiazdek

Installation Guide

e

ProSafe 10GBASE-T RJ-45 Port Adapter AX745

The ProSafe® 10GBASE-T RJ-45 Port Adapter AX745 enables 10 Gigabit Ethernet

RJ-45 connections to be used with NETGEAR GSM73xxS/GSM73xxSv2 series

managed switches. The switches include GSM7328S, GSM7352S, GSM7328FS,

and the M5300 series.

Package Contents

• ProSafe 10GBASE-T RJ-45 Port Adapter AX745

• Installation guide

.

AX745

Install an Adapter

The adapter fits into the I/O slot in NETGEAR managed switches.

The I/O slots are on the front or the rear panel of a switch depending on the switch

model.

Note: The adapter is not hot swappable. You must reboot the switch after installing

or removing an adapter.

I/O

slots

To install an adapter:

1. Insert the adapter into one of the available I/O slots, pressing firmly to seat the

adapter.

2. Once the adapter is seated, tighten the two set screws to hold the adapter in

place.

3. Reboot the switch.

To remove an adapter:

1. Loosen the two set screws on either side of the adapter front panel.

2. Remove the adapter by holding the screw posts and pulling evenly on the

adapter.

3. Reboot the switch.

LED Indicator

The LED on the adapter front panel indicates data speed or link status depending on

the operating mode. See the switch CLI manual or software administration manual

for instructions for setting the LED operating modes.

Operating ModeLED Description

SPD modeGreen = 10 Gbps

Yellow = 100 M/1 Gbps

Link/ACT modeOff = no link

Green = link

Blinking = active link

AX745 IG_14Nov2012.fm Page 1 Wednesday, November 14, 2012 1:06 PM

Specyfikacje produktu