Instrukcja obsługi Pioneer ND-BC5

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Pioneer ND-BC5 (16 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 19 osób i została oceniona przez 8 użytkowników na średnio 4.7 gwiazdek

PIONEER CORPORATION

11,Shinogura,Saiwaiku,Kawasakishi,Kanagawa2120031,- - - - - JAPAN

PIONEER ELECTRONICS (USA) INC.

P.O. - Box1540,LongBeach,California908011540,U.S.A.

TEL: -(800)4211404

PIONEER EUROPE NV

Haven1087,Keetberglaan1,B9120Melsele,Belgium/Belgique -

TEL: (0)3/570.05.11

PIONEER ELECTRONICS ASIACENTRE PTE. LTD.

253AlexandraRoad,#0401,Singapore159936 -

TEL:--6564727555

PIONEER ELECTRONICS AUSTRALIA PTY. LTD.

5ArcoLane,Heatherton,Victoria,3202Australia

TEL: -(03)95866300

PIONEER ELECTRONICS OF CANADA, INC.

340FerrierStreet,Unit2,Markham,OntarioL3R2Z5,Canada

TEL:---18772835901

TEL:--9054794411

PIONEER ELECTRONICS DE MEXICO, S.A. de C.V.

Blvd. ManuelAvilaCamacho13810piso

Col. LomasdeChapultepec,Mexico,D.F.11000

TEL:--5591784270

©2011PIONEERCORPORATION.

Allrightsreserved.

©2011PIONEERCORPORATION.

Tousdroitsdereproductionetdetraduction

réservés.

PrintedinJapan

ImpriméauJapon

<CYR1084A>EL<KFWNX><11F00000>-

UNIVERSAL REAR-VIEW CAMERA

CAMERA DE RECUL UNIVERSELLE

Owner’s Manual

Mode d’emploi

ND-BC5

①Glass surface

②Make sure it doesn’t touch the wiper

③Install on the center part

Fig. 1

Abb. 1

𝖠 Rear view camera Power supply unit ×1𝖢×1𝖡RCA power supply cable × 1

𝖣Hexagon wrench × 1𝖤Hook and loop fastener

(soft type) × 1

𝖥Hook and loop fastener

(hard type) × 1

𝖧Waterproof

pad × 1

𝖦Clamp × 6𝖨Double-sided

tape × 1

Fig. 4

Abb. 4

Fig. 8

Abb. 8

Fig. 6

Abb. 6

Fig. 9

Abb. 9

②Bumper or rear edge of car

①Power supply unit

②Hook and loop

fastener

(hard type)

③Hook and loop

fastener

(soft type)

①Camera

stand

Fig. 2

Abb. 2

Fig. 3

Abb. 3

This device complies with part 15 of the FCC

Rules.

Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference,

and (2) this device must accept any interference

received, including interference that may cause

undesired operation.

Information to User

Alteration or modifications carried out without

appropriate authorization may invalidate the user’s

right to operate the equipment.

Note:

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation.

This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there

is no guarantee that interference will not occur in a

particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment

off and on, the user is encouraged to try to correct

the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV

technician for help.

If you want to dispose this product, do not

mix it with general household waste. There

is a separate collection system for used elec-

tronic products in accordance with legisla-

tion that requires proper treatment, recovery

and recycling.

Private households in the 25 member states of the

EU, in Switzerland and Norway may return their

used electronic products free of charge to designated

collection facilities or to a retailer (if you purchase a

similar new one).

For countries not mentioned above, please contact

your local authorities for the correct method of dis-

posal.

By doing so you will ensure that your disposed prod-

uct undergoes the necessary treatment, recovery and

recycling and thus prevent potential negative effects

on the environment and human health.

WARNING:

Handling the cord on this product or cords associated

with accessories sold with the product may expose

you to chemicals listed on proposition 65 known to

the State of California and other governmental enti-

ties to cause cancer and birth defects or other repro-

ductive harm. Wash hands after handling.

IMPORTANT

SAFEGUARDS

• Installation and wiring of this product require spe-

cialist skill and experience. To assure your safety,

please request a specialist technician to install the

unit.

• Do not attempt to heat the surface of the camera

lens or camera lens itself with a lighter and so on

when they have become frozen. This can cause a

malfunction.

• This product is a rear view camera for checking

the view at the rear of a car.

A rear view camera is a camera that provides sym-

metrical images in the same way as rear and side

view mirrors.

• Connection to a TV with an RCA video input is

possible, but confirm whether the TV you use has

a reverse gear connection function.

• This product is designed to supplement the driver’s

rear view, but the camera images do not show all

dangers and obstacles. Be sure to look behind you

when reversing to confirm the view.

• This product features a wide-angle lens, so the

near view is wide and the far view is narrow,

which may create a false sense of distance. Be

sure to look behind you when reversing to confirm

the view.

• Do not wash your car with an automatic car wash

or high-pressure water as it may result in water

entering the camera or the camera falling off.

• Check camera stand installation before driving.

Are the screws loose?

– Is the camera stand firmly secured?

– If the rear view camera comes loose while you

are driving it may cause an accident.

⑥Be sure not to hide any part of the char-

acters on the license plate when attaching

the camera.

Fig.5

Abb. 5

Fig. 7

Abb. 7

②Top

③Mark

④Bottom

⑤Make sure to install the rear view camera so

that the mark is located on top of the camera.

①Hexagon wrench

Specyfikacje produktu