Instrukcja obsługi Samsung MIM-B14

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Samsung MIM-B14 (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 18 osób i została oceniona przez 9 użytkowników na średnio 4.9 gwiazdek

English

EXTERNAL CONTROLLER INSTALLATION

Parts

PRODUCT

NAME

EXTERNAL

CONTROLLER PCB CASEHARNESS WIRESSCREW

QUANTITY1EA1EA1EA for EACH WIRE2EA

SHAPE

Installation

1. Fix PCB case() inside the indoor unit control box or at an appropriate position with screws ().

2. After fixing PCB cases, attach the external controller PCB. (See the following figure, Assembly Drawing)

3. Connect 2 pin wire () between the external controller PCB CN83 and indoor unit PCB EXT_CTRL connector(CN83).

4. Connect 4 pin wire () between the external controller PCB CN81 and indoor unit PCB COMP/ERROR

connector(CN81).

Installation option setting of indoor unit

Indoor unit with DIP S/W

Operation Specification according to Indoor Unit PCB installation option Set up

WIRE NO.OUTPUT STATE

K11 OFFK11 & K12 OFF

1,2 Error Check

3,4 COMP. CheckOperating Check

5,6 Signal Input (TIMER)

[figure, Assembly Drawing]

SCREW PCB CASE

SCREW fixing

Positions

Screw fixing positions

when necessary

WIRE

WIRE

Align the case locking with the PCB locking

Indoor unit without DIP S/W

Purpose5, 6 INPUT3, 4 OUTPUT1, 2 OUTPUT

Turn on/off the indoor unit via

external contact controlDRY CONTACTTHERMO ON/OFF or

OPERATION ON/OFF

ERROR STATUS

(Normal Close)

Control external heaterExternal heater’s Switch

Turn on/off the indoor unit via

external contact control and

control external heater

(1*)

DRY CONTACTExternal heater’s Switch

(*1) When the purpose is to use as external heater’s on/off signal, monitoring signal for external contact control will not

be outputted.

Circuit diagram of external controller’s output

For turning on/off the indoor unit via external contact control

AC LAMP

For controlling external heater (On/Off)

Circuit diagram for using external heater for the indoor units without hot water coil terminal

AC

Relay External

Heater

Detailed method about Installation option establishment

refers to Indoor Unit manual. (External contact control

setting: Refer to SGE14, SGE15 of 02 Series installation

option External heater control setting: Refer to SEG15

of 02 Series Installation Option and SEG18 of 05 Series

installation option))

Dry contact(no power source contact) must be be

connected to the input terminal 5,6.

When MIM-B14 is used for controlling external heater, its

contact should not be connected directly to the load.

(Only use as switch as shown in above diagram.)

DB98-26202A-03

SOL MIM-B14 IM-EN,TR_DB98-26202A-03_A5.indd 22-232016-06-20 오후 7:48:40

Specyfikacje produktu