Instrukcja obsługi SurgeX SA-1810

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla SurgeX SA-1810 (1 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 21 osób i została oceniona przez 2 użytkowników na średnio 4.7 gwiazdek

SurgeX

Installation Instructions

SA966, SA1810, SA15, SA20

120 Volt Connections

The SurgeX stand alone products are designed to operate from a 120V 15 amp AC service (20

amp for the SA20). Connect power to a unit by plugging the power cord into a 120V ac

receptacle.

The SA966 is rated for a maximum load of 8 amps. The SA1810 and SA15 are rated for a

maximum load of 15 amps. The SA20 is rated for a maximum load of 20 amps. Plug the

equipment power cords into the receptacles asneeded to provide safe, filtered power to

the equipment.

Under no circumstances should the product be usedwith a “ground lifter” or any other device

which disconnects ground fromthe SurgeX. Doi ng so will create a safetyhazard and could

constitute danger to life.

Mounting

The SurgeX SA products are shipped with four stick-on rubber feet. These can be attached to the

underside of the unit to prevent damage to cosmetic surfaces or to prevent the unit from slipping

on a smooth surface.

Optional brackets (ordering co

de: SA-B) allow the unit to be mounted permanently inside a

cab

inet or toany flat surface. To attach the brackets to the SurgeX, first remove the two screws

in the middle of each side. Attach the brackets with the samescrews making sure these screws

are adequately tightened.

Indicator Lights

The green Self-Test lightindicates that power is applied to theunit and thernal surge inte

protection circuitry is fully functional. If this light is not on when the unit is plugged into the AC

check that AC is present at the receptacle where the unit is plugged in.

If at any point the Self-Test light should go out, first make sure that AC ispresent at the

receptacle where the unit is plugged in. If the light is still off once this has been checked then it

will be necessary to return the unit to SurgeX for repair.

Specyfikacje produktu