Instrukcja obsługi TOA HY-MT7

TOA Niesklasyfikowane HY-MT7

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla TOA HY-MT7 (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 5.5 użytkowników na średnio 5.0 gwiazdek

Pobierz PDF

Strona 1/4

1. SAFETY PRECAUTIONS

• Beforeinstallationoruse,besuretocarefullyread

all the instructions in this section for correct and

safeoperation.

• Besuretofollowalltheprecautionaryinstructions

in this section, which contain important warnings

and/orcautionsregardingsafety.

• After reading, keep this manual handy for future

reference.

• Donotuseothermethodsthanspeciedtomount

theadapter.Extremeforceisappliedtotheadapter

andthematchingtransformercouldfalloff,possibly

resultinginpersonalinjuries.

• Tighten each nut and bolt securely. Ensure that

the adapter has no loose joints after installation

to prevent accidents that could result in personal

injury.

• Use the specied matching transformer in

combination. Doing otherwise may cause the

adapterormatchingtransformertofalloff,resulting

inpersonalinjury.

• Avoidinstallingthespeakerinlocationsclosetothe

seashore or in indoor swimming facilities that are

not well ventilated. In such locations, the adapter

maybevulnerabletocorrosion,eventuallyallowing

thematchingtransformertofallresultinginpersonal

injury.

Indicatesapotentiallyhazardoussituationwhich,

ifmishandled,couldresult inmoderateorminor

personalinjury,and/orpropertydamage.

CAUTION

• Avoid touching the adapter’s sharp metal edge to

preventinjury.

• Havetheadaptercheckedperiodicallybytheshop

from where it was purchased. Failure to do so

may result in corrosion or damage to the adapter

that could cause the matching transformer to fall,

possiblycausingpersonalinjury.

2. GENERAL DESCRIPTION

The HY-MT7 Matching Transformer Adapter is

designed to mount an optional MT-200 Matching

Transformer*totheHX-7SeriesSpeakerSystem.

* The Matching Transformer is used to convert low

impedancetohighimpedance(100Vor70Vline).

 Refer to the MT-200’s Operating Instructions for

moredetails.

3. MT-200 MOUNTING ExAMPLE

Note

When joiningtwospeakersystems, a separate MT-

200 Matching Transformer must be attached to the

secondspeakersystemaswell.Themountingmethod

isthesameasthatfortheinitialspeakersystem.

INSTALLATION MANUAL

MATChING TRANSFORMER ADAPTER hY-MT7

ThankyouforpurchasingTOA’sMatchingTransformerAdapter.

Pleasecarefullyfollowtheinstructionsinthismanualtoensurelong,trouble-freeuseofyourequipment.

Indicatesapotentiallyhazardoussituationwhich,

if mishandled, could result in death or serious

personalinjury.

WARNING

MT-200

HX-7 Series speaker

Step 1. RemovetheMT-200’scover.

Step 2. Changetheprimaryconnectiontap.

ThetapoftheMT-200isfactory-presetto167Ω.

Changethesettingasrequired.

To change the tap, reconnect the primary black cord

accordingtothetablebelow.

Tap

Line 25Ω 50Ω 83Ω 167Ω

100Vline

–

200W 120W 60W

70Vline 200W 100W 60W 30W

Note: NevertouchthewhitecordconnectedtotheCOMtap.

4. MOUNTING ThE MT-200 MATChING TRANSFORMER

BeforemountingtheMT-200,layoutaprotectivesheet,corrugatedcardboardorothersoftmaterialonaat

surface,andperformallworkonthespeakerwithitsfrontbafefacingdownward.

Speaker module

Speaker system

Note

Each HX-7 Series Speaker System

consists of four speaker modules.

Tightentheboltssecurely,asinstructedbelow.

Failuretofollowinstructionspreciselycouldresultinafallingspeaker

andpotentialpersonalinjury.

• Ensurethatallboltsaresecurelyinsertedasfarastheirthreadsgo,

thensecurelyfasteneachboltwithanut.

• Tighten all the bolts with the designated tightening torque. For

tightening,useaPhillipsscrewdriver,oropen-orbox-endwrench.

WARNING

Cover

Cover fixing screw

MT-200

COM

25 50 83 167Ω Ω Ω Ω

White (–)

Black (+)

Step 3. MounttheMT-200tothisadapter.

Mount the MT-200 as shown in the gure at

right.Itscompletedinstallationisshowninthe

“MT-200MountingExample”gureonthefront

page.

Tip

BesuretokeeptheMT-200’scoverremoved.

Note

Wheninstallingspeakersystemsundereaves,

besuretoinstallinaverticalarray.Further,to

ensure the MT-200’s waterproong capability,

install it so that its top panel surface is tilted

within45ºoftheverticalplane.

If the MT-200’s waterproong capabilities

cannot be ensured by the mounting method

shown in the gure at upper right, mount the

MT-200asshownatlowerright.

Refertotheoperatinginstructionssuppliedwith

theMT-200.

MT-200 (without cover)

This adapter

Tightening torque:

8 N·m

Hex head bolt (supplied

with the MT-200)

Plain washer for M8

(accessory)

Nut for M8

(accessory)

Step 4. Mountthisadaptertotherearpanelofthespeakermodule.

This adapter can be attached to any

speaker module, however there may be

cases in which they cannot be easily

attached due to their combination with

otheroptionalmountingbrackets.Insuch

cases, attach this adapter to any free

speakermodule.

This adapter

Hex head bolt M6 x 16

(with spring and plain

washers, accessory)

Tightening

torque: 3 N·m

MT-200

45°

Top surface

MT-200 (without cover)

Tightening torque:

8 N·m

Hex head bolt (supplied

with the MT-200)

This adapter

Plain washer for M8

(accessory)

Nut for M8

(accessory)

Specyfikacje produktu

Marka:	TOA
Kategoria:	Niesklasyfikowane
Model:	HY-MT7
Kolor produktu:	Czarny
Wysokość produktu:	70 mm
Szerokość produktu:	30 mm
Głębokość produktu:	28 mm
Waga produktu:	140 g
Materiały:	Stal nierdzewna