Instrukcja obsługi Vemer RX7-5A
                    Vemer
                    
                    Niesklasyfikowane
                    
                    RX7-5A
                
                                
    Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Vemer RX7-5A (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 12 osób i została oceniona przez 6.5 użytkowników na średnio 5.0 gwiazdek
                        Strona 1/2
                    
                    
                    
User Manual
REMOTE ACTUATOR MODEL RX7-5A
Read all the instructions carefully
V3IS00647-010
Mod. RX7-5A
  The remote actuator RX7-5A is an electronic independently mounted automatic control for 
heating and air conditioning applications, designed for comunications in the range of Vemer 
thermostat and programmable thermostat via radiofrequency or via bus. 
  It provides a type 1B actions and it is designed for household and similar use with overvoltage 
category III and pollution level 2 (EN 60730-1).
 SAFETY WARNINGS
  During product installation and operation, the following safety instructions should be 
respected:
1)  The instrument should be installed by qualied personnel
2)   Before touching the terminals, make sure there is no power supply to the electric wires
3)  Do not power or connect the instrument if any part of it is damaged
4)  Follow the connection diagrams descripted on this manual and over the instrument
5)  The electrical system of the building in which the instrument is to be installed should have a 
switch and a protective device against over-currents. 
6)    The instrument must be installed and activated in compliance with current electric systems 
standards
7)    After installation, inaccessibility to the connection terminals without appropriate tools must 
be granted.
Code  Model  Description
VE443800  RX7-5A  Remote actuator
 TECHNICAL SPECIFICATIONS
•  Power supply: 230 VAC (-15%/+10%) 50/60 Hz
•  Absorption: 3 W (8 VA)
•  Outputs:
  – 6 relays with normally open contact 5A/250 V AC for zone valvs activation
  – 1 relays with normally open contact 5A/250 V AC for pump activation
  – terminals to connect an external antenna (included in the box)
  – serial port for Athena network connection (RS-485)
•  Relay 7 switchting delay setting from 3 second to 5 minutes by trimmer
•  Terminals for cable with 6 mm2 maximum section
•  Operating temperature: 0°C ÷ 50°C
•  Storage temperature: -10°C ÷ 65°C
•  Operating humidity: 20 ÷ 90% non condensing
•  Enclosure: 4 module DIN
•  Protection degree: IP20 (IP40 when correctly installed in an electrical panel)
•  Insulation: reinforced among frontal and all other terminals
OPERATION
  GREEN LED: operation function (power supply)
  RED LEDS: relay status (output 1 - 6)
  YELLOW LED: relay status (output 7)
  SET KEY for programmation and reset channel
  TRIMMER  to set the relay 7 switching delay
Network example
 OPERATION
•  In starting phase, the red leds and yellow led ashes twice for some seconds (switching on- 
sequence). 
•  At the end of the switching on-sequence, the green LED signal normal device operation and 
the red LEDs relay status (light on = relay ON).
  If at least one of the zone valve output (relay 1 ... relay 6) is turn on, automatically is 
also activated the pump output (relay 7), with a delay that can be set from 3 seconds to 5 
minutes by trimmer on the front of the instrument. 
•  The remote control (relay commutation ON/OFF) request from thermostats and 
programmable thermostats take place only after channel setting-up. 
•  The radio connection break down for more than 15 minutes between the transmitter 
and the receiver disconnects the relay/relays and the red LED/LEDs lightened. Restore of 
operations is automatic.
  Channel setting-up
  –   During normal operation, press the SET key-button for almost three seconds to enter in 
modality-conguration. Green LED switch-off, red LED ash. Press the SET key-button 
to select the output relay.
  –   The instrument keep on modality-conguration for a maximum of 60 seconds within 
the actuator should receive a string conguration (see thermostats or programmable 
thermostats instructions for string start-up modality).
  –   On receipt of string, channel is setted-up and the actuator is on standard functioning.
  –   For re-setting up, repeating the procedure.
•  To reset channel setting-up, plug into conguration modality with SET button, then push 
the same one for three seconds and wait for green led switching on. 
 SERIAL OUTPUT
  RX7-5A features an insulated serial output RS 485 for communication. It is possible to 
connect up to 31 instruments up to a maximum distance of 40 m.
Note:  It is possible to connect a remote actuator with different programmable 
thermostats Athena. In this case it is necessary to congure different zones 
for each Athena. Exemple: 2 Athena are connected with a remote actuator: if 
Z1 is selected in the rst Athena, then Z2, Z3 or Z4 must be selected in the 
second Athena.
 STANDARDS REFERENCE
Conformity to the EU directives:
2006/95/EC (Low Voltage)
2004/108/EC (Electromagnetic Compatibility)
is declared with reference to the following harmonized standard:
EN 60730-1
EN 301 489-1/3 and EN 300 220-1/2
- Living room probe: built into Athena programmable thermostat
- Bedroom probe: remote, connection to Athena via bus 485 
- Bathroom probe: built into Klio
- Entrance probe: remote, connection to Athena via bus 485
- Kitchen probe: built into Mithos RF
The air-conditioning equipment is controlled by means of a remote actuator (RX7-5A) via RF 
and/or 485 bus.
Dimensions
Connection diagram
Description
8787
60
65
45
7272
out 7
230V~
50/60 Hz
out 1
out 2
out 3
out 4
com 1-2
com 3-4
com 5-6
out 5
out 6
Athena.temp
ACTUATOR
Boiler
ATHENA
+Tx.Athena
Bedroom
Bathroom
Living room
KitchenEntrance
Athena.temp
RF
BUS
Mithos RF
T3
T2
T1
Klio
Specyfikacje produktu
| Marka: | Vemer | 
| Kategoria: | Niesklasyfikowane | 
| Model: | RX7-5A | 
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Vemer RX7-5A, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Niesklasyfikowane Vemer
                        
                         4 Października 2024
                        
                    
                                                            
                        
                         3 Października 2024
                        
                    
                                                            
                        
                         1 Października 2024
                        
                    
                                                            
                        
                         27 Września 2024
                        
                    
                                                            
                        
                         22 Września 2024
                        
                    
                                                            
                        
                         22 Września 2024
                        
                    
                                                            
                        
                         21 Września 2024
                        
                    
                                                            
                        
                         21 Września 2024
                        
                    
                                                            
                        
                         18 Września 2024
                        
                    
                                                            
                        
                         16 Września 2024
                        
                    
                                                            Instrukcje Niesklasyfikowane
- Leica
- CradlePoint
- Xvive
- Socomec
- Ixxat
- IBEAM
- Alpen Kreuzer
- Terratec
- Crest Audio
- Fostex
- Fanox
- LARQ
- Livington
- Wegman
- AstralPool
Najnowsze instrukcje dla Niesklasyfikowane
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025