Instrukcja obsługi Bresser 2080201

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bresser 2080201 (3 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 15 osób i została oceniona przez 3 użytkowników na średnio 4.2 gwiazdek

Changing the nozzle

1. Press [Filament], then press [Change]. The extruder unit is

heated up.

Wait until the target temperature is reached.

2. Open the filament

compartment cover.

3. Pull out the filament as shown in the

illustration.

Heating extruder...

200 /235℃

Cancel

Load

Change

Wait minimum 15 minutes until the extruder

and the nozzle have cooled down.

Power off the printer after all parts are

cooled down.

4. Push the clips (7) with one hand and pull

the nozzle (5) downwards out of the extruder

with the other hand.

5. Push the new nozzle into the extruder with

its plug (X) facing backwards until it is

firmly fixed.

5. Power on the printer and re-insert the filament

(see chapter “Changing the filament”).

Note

The nozzle is tightly fixed in the extruder.

Therefore wiggle back and forth a little if

necessary and pull strongly.

Make sure to push the clips the whole time.

Note

7

5

X

GB

German version on opposite page! · Deutsche Fassung umseitig!

Plus d'informations ou des traductions disponibles sur · Meer informatie of de beschikbare vertalingen onder

Informazioni esaustive o traduzioni disponibili su · Información completa o traducciones disponibles en · Informações

abrangentes ou traduções disponíveis em www.bresser.de/P2080201

Specyfikacje produktu