Instrukcja obsΕ‚ugi Digigram LX-MADI

Digigram Niesklasyfikowane LX-MADI

Przeczytaj poniΕΌej πŸ“– instrukcjΔ™ obsΕ‚ugi w jΔ™zyku polskim dla Digigram LX-MADI (20 stron) w kategorii Niesklasyfikowane. Ta instrukcja byΕ‚a pomocna dla 13 osΓ³b i zostaΕ‚a oceniona przez 7 uΕΌytkownikΓ³w na Ε›rednio 5.0 gwiazdek

Pobierz PDF
Strona 1/20
LX-MADI
User Manual    v1.4 Nov 2016
LX-MADI
Multichannel MADI PCI Express Sound Card
User Manual

0
LX-MADI
User Manual    v1.4 Nov 2016
Table of contents
   
1 INFORMATION FOR THE USER        
2 IMPORTANT NOTICE    
3 FEATURES  
Main hardware features    
3.2 Main software features      
3.3 MADI features    
4 REQUIREMENTS  
4.1 Minimum hardware requirements      
Software requirements  
Supported operating systems    
5 SOFTWARE INSTALLATION AND CONFIGURATION UNDER WINDOWS            
5.1 Installation under Windows operating systems          
5.2 Microsoft volume mixer panel        
5.3 ASIO driver configuration      
6 HOW TO CHECK THE INSTALLATION UNDER WINDOWS              
7 UNINSTALLING THE DRIVERS UNDER WINDOWS          
8 SPECIFICATIONS  
8.1 Configuration  
8.2 Inputs/Outputs  
8.3 Connectors  
8.4 Development environments    
9 APPENDIX  
9.1 LX-IP schematic diagram      
9.2 Connectors  


 
1
LX-MADI
User Manual    v1.4 Nov 2016
1 INFORMATION FOR THE USER
       
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions contained in this data sheet, may cause harmful interference to radio and television communications. However, there is
no guarantee that interference will not occur in a particular installation.                   
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:                                       
● reorient or relocate the receiving antenna          
● increase the separation between the equipment and the receiver               
● connect the equipment into an outlet on a circuit different from that of the receiver                           
● consult the dealer or an experienced radio / television technician.                 
Note: Connecting


this


device


to


peripheral


devices


that


do


not


comply


with


CLASS


B requirements


or


using


an


unshielded
peripheral


data


cable


could


also


result


in harmful


interference


to


radio


or


television


reception.
To


ensure


that


the


use


of


this


product


does


not


contribute


to


interference,


it


is


necessary


to


use


shielded


I/O


cables.
The


user


is


cautioned


that


any


changes


or


modifications


not


expressly


approved


by


Digigram


could


void


the


user’s
authority


to


operate


this


equipment.
Warning:
Electrostatic discharge (ESD) can damage several components on the board. To
avoid


such


damage


in


handling


the


board,


take


the


following


precautions:
Bring the device and everything that contacts it to ground potential by providing
a conductive surface and discharge paths. As a minimum, observe these
precautions:
●Disconnect


all


power


and


signal


sources.
●Place


the


device


on


a


grounded


conductive


work


surface.
●Ground


yourself


via


a


grounding


wrist


strap


or


by


holding


a
grounded


object.
●Ground


any


tool


that


will


contact


the


device.
2 IMPORTANT NOTICE   
This card has been tested and found to comply with the following standards:                       
● International: CISPR22 Class B.     
● Europe: EMC 89/336/CEE (1992) specifications.       
● United States: FCC Rules-Part 15-Class B (digital device).             
2

Specyfikacje produktu

Marka: Digigram
Kategoria: Niesklasyfikowane
Model: LX-MADI

Potrzebujesz pomocy?

JeΕ›li potrzebujesz pomocy z Digigram LX-MADI, zadaj pytanie poniΕΌej, a inni uΕΌytkownicy Ci odpowiedzΔ…


Instrukcje Niesklasyfikowane Digigram

Digigram

Digigram LX-MADI Instrukcja

11 Grudnia 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

SmallRig

SmallRig VB99 SE Instrukcja

29 Stycznia 2025
Rock N Roller

Rock N Roller R14G Instrukcja

29 Stycznia 2025
Rock N Roller

Rock N Roller R6RT Instrukcja

29 Stycznia 2025
QSC

QSC TSC-8 Instrukcja

29 Stycznia 2025
XTRARM

XTRARM XTR-FS5130 Instrukcja

29 Stycznia 2025
Sunding

Sunding SD-581G Instrukcja

29 Stycznia 2025
XTRARM

XTRARM XTR-FS5070 Instrukcja

29 Stycznia 2025
XTRARM

XTRARM XTR-FS2010 Instrukcja

29 Stycznia 2025
Shimbol

Shimbol Memory I PRO Instrukcja

29 Stycznia 2025
OSEE

OSEE TX402 Instrukcja

29 Stycznia 2025