Instrukcja obsługi Frigidaire CFPWD15

Frigidaire Niesklasyfikowane CFPWD15

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Frigidaire CFPWD15 (12 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 25 osób i została oceniona przez 13 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/12

El no desconectar el suministro eléctrico an-•

tes de la instalación apilada puede ocasio-

nar lesiones personales o incluso la muerte.

La instalación inadecuada de la ventilación •

de la secadora puede ocasionar lesiones

personales o daños a la propiedad.

Para evitar lesiones en la espalda u otro •

tipo de lesiones, procure levantar o mover

la lavadora o secadora con la ayuda de

más de una persona.

No apile la secadora sobre la lavadora si •

ya está instalada sobre un pedestal.

137333700 A (1002)

Installation Instructions

15” Pedestal

Instructions d’installation

Socle de 38 cm (15 po)

Instrucciones de Instalación

Pedestal de 15" (38,1 cm)

Adjustable wrench

Clé à molette

Llave ajustable

Carpenter’s level

Niveau de charpentier

Nivel de carpintero

Optional universal

wrench available

from dealer

Clé universelle

optionnelle (en vente

chez le détaillant)

Llave universal opcional

(disponible a través

de su distribuidor local)

Phillips screwdriver

Tournevis Phillips

Destornillador Phillips

AND

9/16” or 14 mm box wrench

Clé polygonale de

9/16 po ou de 14 mm

Llave de cubo de

9/16 po o 14 mm

26.5”

(67 cm)

42.5”

(108 cm)

15”

(38 cm)

27”

(68.5 cm)

Failure to disconnect from power source •

before stacking could result in personal

injury or even death.

Improper installation of dryer venting •

could result in personal injury or damage

to property.

To avoid back or other injury, have more •

than one person move or lift the washer

or dryer.

Do not stack a dryer on top of washer •

already installed on pedestal.

Ne pas débrancher l’appareil de sa source •

d’alimentation en électricité avant de le super-

poser peut causer des blessures, voire la mort.

Une installation inappropriée du système •

de ventilation de la sécheuse peut causer

des blessures ou des dommages matériels.

Pour éviter les blessures au dos ou •

d’autres types de blessure, demandez

l’aide d’autres personnes pour déplacer

ou soulever la laveuse ou la sécheuse.

Ne superposez pas une sécheuse sur •

une laveuse déjà installée sur un socle.

Le poids total DANS un tiroir fermé ou une com-

binaison du poids DANS et SUR le tiroir ouvert ne doit pas excéder

29,5 kg (65 lb).

Total weight IN closed drawer or combination of IN

and ON TOP OF open drawer should not exceed 65 lb. (29.5 kg).

El peso total DENTRO del cajón cerrado o el peso

combinado de los artículos que estén DENTRO y ENCIMA del cajón

abierto no debe exceder las 65 lb (29,5 kg).

English continued on page 2. Pour la suite de la version française,

reportez-vous à la page 5.

La versión en español continúa en la página 8.

WARNING AVERTISSEMENT ADVERTENCIA

Tools needed: / Outils nécessaires: / Herramientas necesarias:

GREEN KIT COMPONENTS:

2 Front brackets.A

2 Rear brackets.B

COMPOSANTS DU NÉCESS. VERT:

2 supports avant.A

2 supports arrière.B

PIEZAS DEL KIT VERDE:

2 soportes delanteros.A

2 soportes traseros.B

SCREW KIT COMPONENTS:

14 #10 (16 x .500) screws.C

COMPOSANTS DU NÉCESSAIRE DE VIS:

14 vis n° 10 (16 x .500).C

PIEZAS DEL KIT (TORNILLOS):

14 tornillos n.º 10 (16 x .500).C

Allow for approximately 5 in. (12.5 cm) behind the

pedestal for clearance of back of washer or dryer to the wall.

Allow additional space if venting dryer upward or downward.

If locking nuts are not removed on units with

metal feet, mounting holes in appliance will not align to

mounting holes in brackets.

Due to higher center of gravity of appliance on ped-

estals, some side-to-side rocking is normal during operation.

Vibration can be minimized by assuring appliance is installed

properly, including being level and solid on all four (4) legs by

following these directions.

If washer or dryer is new and has not been installed yet, skip to 1.

step 4.

If dryer is already installed, disconnect dryer from electrical and 2.

gas connections and exhaust venting.

If washer is already installed, disconnect washer from electrical 3.

connection. Turn off hot and cold water supply and disconnect

hot and cold water supply hoses from water supply outlets.

Disconnect drain hose from drain pipe. Remove hole plugs from

back sheet and reinstall shipping braces and bolts.

Protect ﬂ oor and unit with cardboard or rug and carefully lay the 4.

appliance on its side and screw each leg completely into the base.

Prepare appliance for mounting

Prepare pedestal before mounting

Locate pedestal 1.

to within a few

inches of its

ﬁ nal location.

Level the pedestal 2.

front-to-back and

side-to-side by ad-

justing each leveling

leg. Keep leg exten-

sion to a minimum.

Rock the pedestal from corner-to-corner to check for stability. 3.

Repeat leveling and rocking until all four (4) feet are sturdy on the

ﬂ oor and pedestal is level.

Without turning the rubber foot, lock each pedestal leg in place 4.

by tightening its lock nut tight against the pedestal base.

DO NOT remove foam!

lock nut

raise lower

adjustable

pliers

If appliance has metal feet with a locking nut, unscrew them, 5.

remove the locking nut and reinstall the feet ﬂ ush to the base.

If feet are not completely screwed in, mounting

holes in appliance will not align to mounting holes in brackets.

DO NOT use open dispenser drawer of washer

or dispenser cavity as hand-hold location when tipping washer

on its side. Serious damage could occur to your washer.

To avoid back - EXCESSIVE WEIGHT HAZARD -

or other injury, have more than one person move or lift the

appliance.

Attach front mounting brackets

Attach rear mounting brackets

DRAWER

1 - Appliance 2 - Side panel style of your appliance 3 - Rear bracket orientation

DRYER 3 indents on side. Rear brackets from •

GREEN kit

Tab A into•

Slot 1•

Arrow pointing to •

back

DRYER 2 indents on

side and 4 inch

knockout for side

venting.

Rear brackets from •

GREEN kit

Tab B into•

Slot 3•

Arrow pointing to •

front

WASHER 3 indents on side. Rear brackets from •

GREEN kit

Tab A into•

Slot 2•

Arrow pointing to •

back

WASHER 3 indents on side

in shape of “lOl”. Rear brackets from •

GREEN kit

Tab A into•

Slot 1•

Arrow pointing to •

front

TAB A

TAB B

DIRECTION

INDICATOR

ARROWS

Attach each front clip to outer-most 1.

set of holes with 2 screws.

Determine your appliance type (washer or dryer) and style of side panel ac-1.

cording to columns 1 and 2 in table below.

Orient rear brackets according to column 3 for your particular model.2.

Attach each bracket with 2 screws through the holes that line up on pedestal.3.

Each rear bracket has tabs marked “A” and “B”.•

Each pedestal has slots in the rear marked “1”, “2” •

and “3”.

Each rear bracket also has 2 arrows indicating •

bracket direction when mounted on the pedestal.

Front brackets from

GREEN kit.

SLOT 1

SLOT 2

SLOT 3

Specyfikacje produktu

Marka:	Frigidaire
Kategoria:	Niesklasyfikowane
Model:	CFPWD15
Kolor produktu:	Pink,Red
Wbudowany wyłącznik:	Tak
Temperatura (maks):	200 °C
Model:	Steam hair straightener
Technologia:	Para
Funkcja jonizacji:	Tak
Ceramiczny promiennik podczerwieni:	Tak
Pielęgnacja jonowa:	Tak
Prostowanie włosów:	Tak
Kręcenie włosów:	Tak
Teksturyzacja włosów:	Nie
Suszenie włosów:	Nie