Instrukcja obsługi PAC RP5-GM41
PAC
Niesklasyfikowane
RP5-GM41
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla PAC RP5-GM41 (6 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 28 osób i została oceniona przez 14.5 użytkowników na średnio 4.4 gwiazdek
Strona 1/6
C
Radio Replacement & Steering Wheel Control Interface
with OnStar Retention for General Motors Vehicles
RP5-GM41
Rev. 092017 Page 1
© 2017 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Important Notes
Wiring Connection Chart
Illustration / Schematic
The RP5-GM41 interface allows the replacement of a factory radio in select General Motors vehicles with 29-bit LAN v2 44-pin connector
radios. Using this interface will retain factory features such as OnStar, Bluetooth, steering wheel controls (SWC), and warning chimes
when the original radio is removed. Use of this interface also allows you to program two radio functions to each SWC button by using
short press long press dual command functionality. The RP5-GM41 also provides data bus driven outputs such as retained accessory
power (RAP), vehicle speed sensor (VSS), illumination, reverse trigger and parking brake.
1. These instructions only apply to R.2.5.6.6 or later revisions. The revision info can be found on a small white sticker on the interface and
packaging.
2. Once the radio has been removed, the vehicle settings which are normally selected through the factory radio can be accessed by downloading
and installing the PAC Vehicle Settings program (for windows PC) from http://www.pac-audio.com/rmware. Please make your vehicle
settings selections before removing the factory radio for optimal installation time.
3. The Answer/Voice & End/Mute buttons can be set to do the factory OnStar functions or given the ability to control the aftermarket radio. This
option can be found in the PAC Vehicle Settings program mentioned above in note one. The default setting for these buttons is to control the
factory OnStar. If these buttons are set to control the aftermarket radio, OnStar can still be accessed by using the mirror controls.
4. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the interface into the
vehicle (see below for setting chart).
5. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless you wish to
re-assign the SWC functions, or utilize the short press long press dual command functionality. The SWC can always be restored to default
settings by pressing and releasing the program button on the side of the interface once and waiting 7 seconds for the LED to ash 4 times.
6. The LED will ash whenever a SWC button is pressed.
SWC Connection
See above chart for
diff er ent radio type
connections
Wiring
Page 1
AUX AUDIO
CAMERA C AMERA
Aftermarket
Radio
Connections
Vehicle
Connections
Light Green Parking Brake Output (-)
Pink Vehicle Speed Output
Orange / White Illumination Output (+)
Purple / White Reverse Output (+)
Brown Loop Mute Loop - See Note
Installation Step 4 on Page 2
Aftermarket Radio Connections
Blue Power Antenna output
from aftermarket radio
SWC Connection
Antenna Adapter
SWC Connector
Blue / Yellow Kenwood, Newer JVC, OEM
or Blaupunkt
3.5mm Jack
Alpine, JVC, Clarion,
Pioneer, Sony, Valor, Boyo,
Dual, Lightning Audio,
Visteon, Jensen or Advent
Red AUX Audio - Right
White AUX Audio - Left
Yellow Reverse Camera 1
IMPORTANT NOTES REGARDING
YELLOW AND BLACK WIRE
CONNECTIONS
* Connect both Yellow wires from the
RP5 harnesses to the radio’s 12v
constant input.
** Connect both Black wires from the
RP5 harnesses to the radio’s ground
input.
RCA Connectors
Yellow Reverse Camera 2
Introduction & Features
Yellow * +12v from RP5
Yellow * +12v from vehicle
Black ** Ground from RP5
Black ** Ground from vehicle
Red Acc. Output
White Front Left + input
White / Black Front Left - input
Grey Front Right + input
Grey / Black Front Right - input
Green Rear Left + input
Green / Black Rear Left - input
Purple Rear Right + input
Purple / Black Rear Right - input RCA Connector
Specyfikacje produktu
| Marka: | PAC |
| Kategoria: | Niesklasyfikowane |
| Model: | RP5-GM41 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z PAC RP5-GM41, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Niesklasyfikowane PAC
28 Grudnia 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
Instrukcje Niesklasyfikowane
- Izzy
- Elta
- ESYLUX
- ISpring
- Satisfyer
- Dnipro
- Sure Petcare
- OBH Nordica
- NAV-TV
- Pure 100
- Woodland Scenics
- Lumens
- UTEPO
- BabyDan
- Kitronik
Najnowsze instrukcje dla Niesklasyfikowane
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025