Instrukcja obsługi Satel PNK-1

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Satel PNK-1 (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 18 osób i została oceniona przez 8 użytkowników na średnio 4.9 gwiazdek

®

PANIC BUTTON

PNK-1

pnk1_en 08/08

The panic button is a device de-

signed to instantly trigger the

alarm and/or initiate the proce-

dure of reporting an emergency

situation in protected facility to

the MONITORING STATION. It

can be used in banks, wholesale

depots, stores, and other

facilities exposed to a direct

assault and robbery.

It can interface with any alarm

control panel which supports the

NC type detectors. Installed

inside the button is a reed relay,

the contacts of which open on

pressing the button.

The button return spring can be

easily removed, thus enabling

the, so-called, mechanical

memory of use. With the spring

removed, the button – after

being pushed in – will remain

inside the casing until it is released with the key. Where a few buttons are

connected to one zone of the alarm control panel, this function makes it

possible to identify the button which triggered the alarm.

INSTALLATION AND CONNECTION

Prior to installation, break off the cable inlet in the base or cover of the

button. The button should be mounted by means of two screws on an even

surface, usually in a concealed place, writing desk. It e.g. under the top of

can be installed either horizontally, or vertically.

If several buttons are connected to one panic zone of the alarm system,

they should be connected in series.

The ends of reed relay should be connected with the cables by means of

field terminals. Three field terminals make it possible to connect the EOL

resistor inside the housing, without the use of a soldering iron.

To make the

installation easier, you can take out the movable button from the base after

slightly deflecting the catches.

Fig. 1. View of the panic button and key

BUTTON

(side view)

(bottom view)

KEY

Specyfikacje produktu