Instrukcja obsługi Shadow SH-SC1

Shadow Niesklasyfikowane SH-SC1

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Shadow SH-SC1 (1 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 20 osób i została oceniona przez 10.5 użytkowników na średnio 3.7 gwiazdek

Pobierz PDF

Strona 1/1

Sensor

copper foil

Fax: (561) 743 0460

eMail: jjmelch@shadow-pickups.com

Shadow Elektroakustik

Peter-Haendel Straße 2

91334 Hemhofen · Germany

Shadow Electronics of America Inc.

17791 Alexander Run

Jupiter, FL 33478 U.S.A.

Fax: +49 - 91 95 - 92 99 30

eMail: info@shadow-electronics.com

Installation Instruction for Shadow SH SC1

Twind Cello Transducer

Inhalt:Inhalt:

Fig. 1Fig. 1

Fig. 2Fig. 2

2 transducer discs (20mm diameter)

output socket (6,3mm) with double sided adhesive

copper foil

2 transducer discs (20mm diameter)

output socket (6,3mm) with double sided adhesive

copper foil

If pickup is too loose, shim with included shim material (see Fig. 2). If pickup is too tight, file the bridge slot slightly.If pickup is too loose, shim with included shim material (see Fig. 2). If pickup is too tight, file the bridge slot slightly.

1. Test fit sensors into the slot between the wing and foot. Pickup should fit tightly for best output (see Fig. 1).1. Test fit sensors into the slot between the wing and foot. Pickup should fit tightly for best output (see Fig. 1).

2. Install the sensors into the bridge slot.

3. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

2. Install the sensors into the bridge slot.

3. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

Note: