Instrukcja obsługi Sonic Alert HA360SSBC

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Sonic Alert HA360SSBC (2 stron) w kategorii Bezpieczeństwo. Ta instrukcja była pomocna dla 41 osób i została oceniona przez 4 użytkowników na średnio 4.1 gwiazdek

INSTALLATION AND SETUP FOR HOMEAWARE™ TRANSMITTER

HA360SSBC – Baby Cry

The HomeAware™ HA360SSBC transmitter is

designed toalert you tothe sound of a baby crying.

Thistransmitter alerts you through the HomeAware™

Main unit and remote receivers located in other rooms.

Battery Backup Installation

Install a new 9 volt alkaline battery into the battery

compartment located on the back of the unit. See

diagram for battery door location. Battery backup will

provide power when a power outage has occurred.

Power will be provided for a continuous outage lasting

7 days, or for short outages up to two years.

Link Button Set Up

This procedure will link the HA360SSBC – Baby Cryto

your Main unit. The Main unit will also provide an alert

to all HomeAware™ remote receivers. When using the

Bridge unit HA360BU all original Sonic Alert receivers

(SA101, SA201, BL300, and SB1000) will also alert

you.

It is best to do the link procedure in the same room with

the HomeAware™ Main unit, make sure the unit is

pluggedin.

To link a transmitter to your HomeAware™ Main

unit:

1.Press set up button and the word LINKwill be

shown on the display, press Enter. LINKwill begin

blinking. (If LINKmode is entered by accident,

simply press the BACKbutton to exit and return to

the clock.)

2. Press and hold down the Link button on the back of

your transmitter for about 1 second. The red LED

on the transmitter will light up. Release the button.

3. Upon successful connection, the red LED on the

transmitter will flash 2 times, then turn off. The

HomeAware™ main unit will briefly show DONE,

and return to the time display. Your transmitter is

now connected and ready to test and use.

Sensitivity Switch

You can adjust the sensitivity of the Baby Cry detector.

There are three levels to choose from:The HIsetting is

the most sensitive setting and will alert you to more

sounds. Moving this switch to MEDmakes it less

sensitive and will alert you to less sound. TheLO

setting is the least sensitive. If youarenot picking up

the sound you need to be alerted to, simply move the

sensitivity switch to a higher setting. If you have set this

setting to HI and you are still not picking up the sound

try moving the transmittercloser to the sound.

When a sound is detected it will send a signal to the

HomeAware™base unit and all HomeAware™ remote

receivers, also the red LEDlight will flash on the front

of the unit.

Low Voltage Input

HomeAware™transmitters havea low 120 volt AC

power supplythat powers the HA360ss. Simply plug

the unit into any 120 volt AC power outlet. Next plug

the other end into the Low Voltage Input located on the

side, see diagram below.

FCC Requirements

This device complies with part 15 of the FCC rules.

Operation is subject to the following two conditions; (1)

This device might not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired

operation.

Specyfikacje produktu