Instrukcja obsługi StarTech.com PEX1S1P950

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla StarTech.com PEX1S1P950 (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 16 osób i została oceniona przez 8 użytkowników na średnio 4.6 gwiazdek

Quick-Start Guide

To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.

Manual Revision: November 2, 2020

Product Diagram (PEX1S1P950)

Front Angle View

PortFunction

1Serial Port

• Connect Serial Peripheral Devices

• DB-9 Parallel (Male)

2Jumper• Set the power output voltage for the Serial Port

3SATA Power Connector

• Connect to a SATA Power Source

• (Optional) Power the Serial Port

4Parallel Port

• Connect Parallel Peripheral Devices

• DB-25 Parallel (Female)

5PCIe Connector

• Connect the to the in PCIe Card PCI Express Slot

the Computer

6Bracket• For full prole installations

Package Contents

• Serial and Parallel PCI Express Card x 1

• Full Prole Bracket (Installed) x 1

• Quick-Start Guide x 1

Requirements

For the latest requirements, please visit:

www.startech.com/PEX1S1P950.

• Computer with an available PCI Express slot (x1)

1S1P Native PCI Express Serial Parallel Combo Card with 16C950 UART

Hardware Installation

Warning: PCIe Cards can be damaged by static electricity. Make sure that the

InstallerComputer Case is properly grounded before they open the or touch the PCIe

Card. The should wear an when installing any computer InstallerAnti-Static Strap

component. If an is not available, discharge any built-up static Anti-Static Strap

electricity by touching a large for several seconds. Only Grounded Metal Surface

handle the by its edges and do not touch the gold connectors.PCIe Card

Jumper Conguration

Note: This is specially designed to allow for power output from the ninth PCIe Card

pin of the for that support power over serial. Serial PortSerial DevicesJumper

conguration is a requirement when connecting that require power Serial Devices

through the .Serial Port

The can be moved into one of three dierent positions in order to set the Jumper

power output voltage for the . The default setting for the is , no Serial PortJumpersRI

power. The must be connected after conguring the SATA Power Connector Jumper

to or of power. To congure the , complete the following:5V12V Jumper

1. Ensure the isComputerPower O.

2. Locateandcarefully remove the . Lift the straight up and o of the JumperJumper

PCIe Card.

Notes: The is located on the left-hand side, labeled as on the JumperSerial 1

. Printed Circuit Board

Always hold the by the edges.Card

3. Determine the power setting that is required for the .Serial Port

4. Position the over the set of that correspond with the desired JumperPinsSerial

Connector Power SettingJumper. See to determine where the Figure 1 should be

positioned.

Figure 1

Jumper

5

1

3

4

6

2

Specyfikacje produktu