Instrukcja obsługi Texas Instruments LP339N

Texas Instruments nieskategoryzowany LP339N

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Texas Instruments LP339N (14 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 14 osób i została oceniona przez 7.5 użytkowników na średnio 3.7 gwiazdek

Pobierz PDF

Strona 1/14

The LP239 is obsolete

nd is no longer supplied.

  

   

SLCS004B − OCTOBER 1987 − REVISED SEPTEMBER 2004

POST OFFICE BOX 655303 • DALLAS, TEXAS 75265

DWide Supply-Voltage Range . . . 3 V to 30 V

DUltralow Power Supply Current

Drain . . . 60 µA Typ

DLow Input Biasing Current . . . 3 nA

DLow Input Offset Current . . . ± 0.5 nA

DLow Input Offset Voltage . . . ±2 mV

DCommon-Mode Input Voltage Includes

Ground

DOutput Voltage Compatible With MOS and

CMOS Logic

DHigh Output Sink-Current Capability

(30 mA at VO = 2V)

DPower Supply Input Reverse-Voltage

Protected

DSingle-Power-Supply Operation

DPin-for-Pin Compatible With LM239, LM339,

LM2901

description/ordering information

The LP239, LP339, LP2901 are low-power quadruple dierential comparators. Each device consists of four

independent voltage comparators designed specifically to operate from a single power supply and typically to

draw 60-µA drain current over a wide range of voltages. Operation from split power supplies also is possible

and the ultra-low power-supply drain current is independent of the power-supply voltage.

Applications include limit comparators, simple analog-to-digital converters, pulse generators, squarewave

generators, time-delay generators, voltage-controlled oscillators, multivibrators, and high-voltage logic gates.

The LP239, LP339, LP2901 were designed specifically to interface with the CMOS logic family. The ultra-low

power-supply current makes these products desirable in battery-powered applications.

The LP239 is characterized for operation from −25° °C to 85 C. The LP339 is characterized for operation from

0 C.°C to 70°C. The LP2901 is characterized for operation from −40°C to 85°

ORDERING INFORMATION

TAVIOMAX

AT 25°CPACKAGE†ORDERABLE

PART NUMBER

TOP-SIDE

MARKING

PDIP (N) Tube of 25 LP339N LP339N

0 C°C to 70° ± 5 mV

SOIC (D)

Tube of 50 LP339D

LP339

0 CC to 70

±5 mV

SOIC (D) Reel of 2500 LP339DR LP339

PDIP (N) Tube of 25 LP2901N LP2901N

−40° ° ±C to 85 C 5 mV

SOIC (D)

Tube of 50 LP2901D

LP2901

SOIC (D)

Reel of 2500 LP2901DR

LP2901

†Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are available at

www.ti.com/sc/package.

  ! " #$%! "  &$'(#! )!%*

)$#!" # ! "&%##!" &% !+% !%"  %," "!$%!"

"!)) -!.* )$#! &#%""/ )%" ! %#%""(. #($)%

!%"!/  (( &%!%"*

1OUT

2OUT

VCC

2IN −

2IN +

1IN −

1IN +

3OUT

4OUT

GND

4IN +

4IN −

3IN +

3IN −

D OR N PACKAGE

(TOP VIEW)

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications o

Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

The LP239 is obsolete

nd is no longer supplied.

  

    

SLCS004B − OCTOBER 1987 − REVISED SEPTEMBER 2004

2POST OFFICE BOX 655303 • DALLAS, TEXAS 75265

schematic diagram (each comparator)

5 µA

IN+

IN−

GND

OUT

6 µA

0.2 µA

VCC

0.2 µA

absolute maximum ratings over operating free-air temperature range (unless otherwise noted) †

Supply voltage, VCC (see Note 1) 36 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Differential input voltage, VID (see Note 2) ±36 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (either input) −0.3 V to 36 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input current, VI ≤ −0.3 V (see Note 3) −50 mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Duration of output short-circuit to ground (see Note 4) Unlimited. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous total dissipation (see Note 5) See Dissipation Rating Table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Operating free-air temperature range, TA: LP239 −25° °C to 85 C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

LP339 0° °C to 70 C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

LP2901 −40° °C to 85 C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Package thermal impedance, θJA (see Notes 6 and 7): D package 86°C/W. . . . . . . . . . . . . . . . . . . . . . . . . . . .

N package 80°C/W. . . . . . . . . . . . . . . . . . . . . . . . . . . .

Operating virtual junction temperature, TJ 150°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Lead temperature range 1,6 mm (1/16 inch) from case for 60 seconds: J package 300°C. . . . . . . . . . . . . . . .

Storage temperature range, Tstg −65° °C to 150 C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

†Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated in the recommended operating conditions is not implied.

Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES: 1. All voltage values, except differential voltages, are with respect to the network ground.

2. Differential voltages are at IN+ with respect to IN −.

3. This input current only exists when the voltage at any of the inputs is driven negative. The current flows through the collector-base

junction of the input clamping device. In addition to the clamping device action, there is lateral n-p-n parasitic transistor action. This

action is not destructive, and normal output states are reestablished when the input voltage returns to a value more positive than

− 0.3 V at T

A = 25°C.

4. Short circuits between outputs to V

CC can cause excessive heating and eventual destruction.

5. If the output transistors are allowed to saturate, the low-bias dissipation and the on-o characteristics of the outputs keep the

dissipation very small (usually less than 100 mW).

6. Maximum power dissipation is a function of T

J(max), θJA, and TA. The maximum allowable power dissipation at any allowable

ambient temperature is P

D = (TJ(max) − T

A)/θ

JA . Operating at the absolute maximum T

J of 150°C can impact reliability.

7. The package thermal impedance is calculated in accordance with JESD 51-7.

DISSIPATION RATING TABLE

PACKAGE TA C≤ 25°

POWER RATING

DERATING FACTOR

ABOVE TA = 25°C

TA = 70°C

POWER RATING

TA = 85°C

POWER RATING

J C1025 mW 8.2 mW/°656 mW 533 mW

The LP239 is obsolete

nd is no longer supplied.

  

    

SLCS004B − OCTOBER 1987 − REVISED SEPTEMBER 2004

POST OFFICE BOX 655303 • DALLAS, TEXAS 75265

recommended operating conditions

LP239 LP339 LP2901

UNIT

MIN MAX MIN MAX MIN MAX

UNIT

VCC Supply voltage 3 30 3 30 3 30 V

Common mode input voltage

VCC = 5 V 0 3 0 3 0 3 V

VIC Common-mode input voltage VCC = 30 V 0 28 0 28 0 28 V

I t lt

VCC = 5 V 0 3 0 3 0 3 V

VIInput voltage VCC = 30 V 0 28 0 28 0 28 V

TAOperating free-air temperature −25 85 0 70 −40 85 C°

electrical characteristics, VCC = 5 V, T

A = 25°C (unless otherwise noted)

PARAMETER TTEST CONDITIONS A†MIN TYP MAX UNIT

Input offset voltage

VCC = 5 V to 30 V,

VO = 2 V,

25 C 2 5° ± ±

VIO Input offset voltage

VCC = 5 V to 30 V,

RS = 0,

VO = 2 V,

See Note 6 Full range ±9mV

I t ff t t

25 C 0.5 5° ± ±

IIO Input offset current Full range ± ±1 15 nA

Input bias current

See Note 7

25 C −2.5 −25°

IIB Input bias current See Note 7 Full range −4 −40 nA

Common-mode input voltage

Single supply

25 C°0 to

VCC − 1.5

VICR

Common mode input voltage

range Single supply

Full range 0 to

VCC − 2

VD Large-signal differential voltage

amplication VCC = 15 V, RL = 15 kΩ500 V/mV

V 1 V

VO = 2 V,

25 C 20 30°

Output sink current VI− = 1 V,

VI= 0

VO = 2 V,

See Note 8 Full range 15 mA

Output sink current

VI+ = 0

VO = 0.4 V 25 C 0.2 0.7°

Output leakage current

VI+ = 1 V,

VO = 5 V 25 C 0.1 nA°

Output leakage current

VI+ = 1 V,

VI− = 0 VO = 30 V Full range 1 Aµ

VID Differential input voltage VI ≤ 0 (or VCC − on split supplies) 36 V

ICC Supply current RL = ∞ all comparators 60 100 Aµ

†Full range is −25°C to 85 C to 70 C to 85°C for the LP239, 0° °C for the LP339, and − 40° °C for the LP2901.

NOTES: 8. VIO is measured over the full common-mode input voltage range.

9. Because of the p-n-p input stage, the direction of the current is out of the device. This current essentially is constant (i.e., independent

of the output state). No loading change exists on the reference or input lines as long as the common-mode input voltage range is

not exceeded.

10. The output sink current is a function of the output voltage. These devices have a bimodal output section that allows them to sink

(via a Darlington connection) large currents at output voltages greater than 1.5 V, and smaller currents at output voltages

less than 1.5 V.

switching characteristics, VCC = 5 V, TA = 25°C, RL connected to 5 V through 5.1 kΩ

PARAMETER MIN TYP MAX UNITTEST CONDITIONS

Large-signal response time

TTL logic swing V 1 4 V

1.3

µs

Response time

TTL logic swing, V

ref

= 1.4 V

8µ

Specyfikacje produktu

Marka:	Texas Instruments
Kategoria:	nieskategoryzowany
Model:	LP339N
Wysokość produktu:	4.57 mm
Szerokość produktu:	19.69 mm
Głębokość produktu:	6.6 mm
Szerokość opakowania:	13.97 mm
Wysokość opakowania:	11.23 mm
Głębokość opakowania:	506 mm
Ilość na paczkę:	25 szt.
Liczba kanałów:	4 kan.
Zakres temperatur (eksploatacja):	0 - 70 °C
Liczba styków:	14
Zakres temperatur (przechowywanie):	-65 - 150 °C
Model:	Komparator
Rodzaj opakowania:	PDIP
Szerokość (z bolcami):	19.69 mm
Głębokość (z bolcami):	10.92 mm
Wysokość (z bolcami):	8.26 mm