Instrukcja obsługi Botex NETcon 1-3
                    Botex
                    
                    Niesklasyfikowane
                    
                    NETcon 1-3
                
                                
    Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Botex NETcon 1-3 (1 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 17 osób i została oceniona przez 9 użytkowników na średnio 4.8 gwiazdek
                        Strona 1/1
                    
                    
                    
Thomann GmbH  •  Hans-Thomann-Straße 1  •  96138 Burgebrach  •  www.thomann.de  •  info@thomann.de         DocID: 451599_13.01.2020
EN
User manual
This manual contains important information on the safe operation of the product. 
Read and follow the safety advice and instructions given. Retain the manual for future 
reference. If you pass the product on to others please include this manual.
NETcon 1 3 Art-Net Node–
For the transport and protective packaging, environmentally friendly materials 
have been chosen that can be supplied to normal recycling. Ensure that plastic 
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected for recy-
cling. Please follow the notes and markings on the packaging.
This product is subject to the European Waste Electrical and  Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old 
device with your normal household waste. Dispose of this product through an 
approved waste disposal rm or through your local waste facility. Comply with 
the rules and regulations that apply in your country. If in doubt, consult your local waste 
disposal facility.
Safety instructions
Intended use
This device is used to distribute ArtNet and Ethernet signals. Any other use or use 
under other operating conditions is considered to be improper and may result in 
personal injury or property damage. No liability will be assumed for damages result-
ing from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are 
not within reach of babies and young children. Choking hazard! Ensure 
that children do not detach any small parts from the product. They could 
swallow the pieces and choke! Never let children unattended use electrical devices.
Where to use the product
Never use the product 
•  in conditions of extreme temperature or humidity
•  in extremely dusty or dirty areas
•  at locations where the unit can become wet
General handling
•  To prevent damage, never use force when handling the product.
•  Never immerse the product in water. Just wipe it with a clean dry cloth. Do not use 
liquid cleaners such as benzene, thinners or ammable cleaning agents.
Features
•  ArtNet / DMX converter
•  Bidirectional ArtNet Node for professional requirements
•  Conguration via built-in display directly on the device
• RDM capable
• Adjustable DMX repeat rate (10–40Hz)
•  For 512 channels / one DMX universe
•  Converts either ArtNet to DMX or DMX to ArtNet
•  Black metal housing
Technical specications
 Connections:    2×Ethernet RJ45 lockable 
      XLR 3-pin. DMX in and output
 Power supply:    via supplied power adapter: DC 5V /10W
 Protective class:    IP20
 Dimensions (W×H×D):  167×130×110mm
 Weight:    0.34kg
Using the product
Press MODE to enter the following menu, then use UP & DOWN to select the desired entry which you call up with SETUP:
1. IP address
2.x.x.x IP type 1, automatically generated, not editable
IP address setting for ArtNet must be made according to the setting 
under IP type (4.).
10.x.x.x IP type 2, automatically generated, not editable
DHCP IP type 3, automatically generated, not editable
192.168.000.008 IP type 4, adjustable by user
2. Subnet mask
255.000.000.000 IP type 1, automatically generated, not editable
Subnet mask setting for ArtNet must be made according to the 
setting under IP type (4.).
255.000.000.000 IP type 2, automatically generated, not editable
DHCP IP type 3, automatically generated, not editable
255.255.255.000 IP type, adjustable by user
3. Universe 000 255–ArtNet universe setting must be made according to the setting under 
IP type (4.).
4. IP type
2.x.x.x (Auto) IP address, automatically generated, not editable
Species the IP type for ArtNet.
10.x.x.x (Auto) IP address, automatically generated, not editable
DHCP IP address, automatically generated, not editable
Custom IP IP address adjustable by user
5. Unicast address xxx.xxx.xxx.xxx For setting the ArtNet unicast address. The validity of a unicast ad-
dress requires the settings ‘DMX | DIR: IN’ and ‘unicast | ON’.
6. DMX Dir In DMX input, conversion DMX -> ArtNet For setting the ArtNet direction.
Out DMX input, conversion ArtNet -> DMX
7. Unicast
On, (Unicast on)
Mode Master Slave Notes:
•  The validity of the unicast setting requires the setting ‘DMX | DIR: IN’.
•  ‘XXX’ means ‘value irrelevant’.
•  The unicast address of master and IP address is the same as in uni-
cast mode. However, there is one special case, for example, the slave 
IP address: 192.168.1.1, master unicast address: In addition to the 
setting of 192.168.1.1, it can also be set to 192.168.1.255, where 255 
is a general address. The last IP range of the slave is 0-254. Therefore, 
we recommend not to use 255 as a special address.
IP address 192.168.1.0 192.168.1.1
Subnet mask 255.255.255.0 255.255.255.0
Universe 0 0
IP type 4) Custom IP 4) Custom IP
Unicast address 192.168.1.1 xxx.xxx.xxx.xxx
DMX Dir OutIn
Unicast On O
O, (Unicast o), Broadcast
Mode Master Slave
IP address 192.168.1.0 192.168.1.1
Subnet mask 255.255.255.0 255.255.255.0
Universe 0 0
IP type 4) Custom IP 4) Custom IP
Unicast address xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx
DMX Dir OutIn
Unicast O O
8. RDM Enable On To enable (On) or disable (O ) the RDM function.
O
9. Frame Rate 10 40(Hz) Sets the DMX repeat rate for ArtNet.–
10. Settings
Lock On Enables (On) or disables (O) automatic display lock. To release the 
display lock, keep [Mode] and [Setup] pressed for 3 sec.O
Back light On Enables (On) or disables (O) backlight auto-o function when not 
in use.O
Factory Yes Reset to delivery condition.
No
11. Exit To exit the menu.
Specyfikacje produktu
| Marka: | Botex | 
| Kategoria: | Niesklasyfikowane | 
| Model: | NETcon 1-3 | 
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Botex NETcon 1-3, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Niesklasyfikowane Botex
                        
                         22 Września 2024
                        
                    
                                                            
                        
                         22 Września 2024
                        
                    
                                                            
                        
                         22 Września 2024
                        
                    
                                                            
                        
                         21 Września 2024
                        
                    
                                                            
                        
                         21 Września 2024
                        
                    
                                                            
                        
                         20 Września 2024
                        
                    
                                                            
                        
                         19 Września 2024
                        
                    
                                                            
                        
                         18 Września 2024
                        
                    
                                                            
                        
                         17 Września 2024
                        
                    
                                                            
                        
                         8 Września 2024
                        
                    
                                                            Instrukcje Niesklasyfikowane
- Mercusys
 - Bracketron
 - Vimar
 - Fetch
 - Inspire
 - PowerBass
 - Nest
 - Media-Tech
 - Zenec
 - Raidsonic
 - BH Fitness
 - BENNING
 - Oregon Scientific
 - Weishaupt
 - STANDIVARIUS
 
Najnowsze instrukcje dla Niesklasyfikowane
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025
                        
                    
                                                            
                        
                         29 Stycznia 2025