Instrukcja obsługi Hayward Pro-Grid C9002SEP

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hayward Pro-Grid C9002SEP (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 41 osób i została oceniona przez 2 użytkowników na średnio 5.0 gwiazdek

ISC9002SEP-00

HAYWARD PRO GRID

D.E. SEPARATION TANK

MODEL C9002SEP

OPERATION

NOTE: BE SURE THE LOCKING KNOB AND DRAIN PLUG ARE SECURELYTIGHTENED.

Stop the pump and set the lter control valve to the backwash position.

Open the by-pass valve (if equipped) and manual air relief valve and start the pump. Close the air relief valve after

all the air is evacuated.

Backwash the lter for approximately 2 minutes (or until water in optionalsight glass is clear).

Stop the pump, set the lter control valve to the lter position and close the by-pass valve (if equipped).

CLEANING

Clean separation tank bag after each lter backwash.

WARNING:

THIS SYSTEM OPERATES UNDER PRESSURE. BEFORE REMOVING TOPCOVER, BE SURE PUMPIS

OFF AND AIR RELIEF VALVE IS OPEN TO RELEASE ALLINTERNALPRESSURE. ALWAYS MAKE SURE

TOPCOVER LOCKING KNOB IS SECURELYTIGHTENED BEFORE TURNING ON PUMP. PERSONAL

INJURYOR PROPERTYDAMAGE COULD OCCUR.

Remove the drain plug, open the air relief valve and allow the water to drain from the separation tank.

Unscrew locking knob (counter clockwise direction).

Carefully lift o top cover to gain access to bag.

Lift out bag and properly dispose of accumulated dirty D.E. into a waste container. Rinse bag.

Carefully re-install bag in separation tank assuring that the bag assembly sits securely on the

collector hub in the bottom of the separation tank body.

Rinse o cover and O-ring to insure a reliable sealing surface. Place cover on separation tank body.

Tighten locking knob in clockwise direction (hand tight only).

Install and tighten drain plug and close air relief valve.

1.

2.

3.

4.

1.

2.

3.

4.

5.

6.

7.

8.

TYPICAL INSTALLATION

OWNER’S GUIDE

RETURN TO

POOL OR

WASTE LINE

To Pool

Specyfikacje produktu